CX1000 Factory Reset

We program and integrate Beckhoff controls. Call us if you need help programming or starting up a Beckhoff system.

 Call +1 (763) 234-3407  Email nick@pcctrl.com

Posted to Beckhoff Blog on Jul 14, 2009


It is possible to do many very useful administrative tasks, including a factory reset of a Beckhoff embedded controller (CX1000, CX9000, CX1020 series) using the Web Administration Interface that is built into the embedded device's image.

This is a documented feature within the Beckhoff Information System, but a search for this topic proved quite difficult and time consuming. Hopefully putting this information here will save others the headache.

Note, the documentation says that this interface is only available on "CE based devices (image 2.16 or higher required)"

CX Web Administration Portal Documentation

You can drill down the left had tree and find help on this topic. There are a lot of other interesting tips and tricks at this path as well.

Infosystem Path to the Web Based Controller Administration Topic

Embedded PC > Operatingsystem > CE > Web based diagnostic and configuration interface

Accessing the TcWebAccess Web Administration Portal

Open a browser and type in the url path below, using to the controller's name or IP address. The browser should connect to the device's web server on port 5120, and open a page that will show several useful functions.

Web Portal URL: http://<ip-or -devicename>:5120/upnpdevice/index.htm
Sample 1: http://192.168.0.123:5120/upnpdevice/index.htm
Sample 2: http://CX_123456:5120/upnpdevice/index.htm